It’s no mystery why ceramic tile is so popular: It’s durable, stain-resistant, easy to clean, and impervious to water. And when properly installed, tiled surfaces last for generations. However, tile does have an Achilles heel: The grout used to fill the joints between the tiles is, by comparison, porous, relatively soft, and easily stained. In most instances, grout can be restored to like-new condition with a good cleaning. In more extreme cases, the only solution is to re-grout the tile.
The Issue: Dirt/Soap Scum
When grout is stained with dirt or soap scum, scrub it with a , hot water, and scouring powder, such as or . Then, rinse with clean water.
The Issue: Mildew
If the grout is mildewed or badly stained, mix a 50/50 solution of and water, and apply it with a sponge or . Wait ten minutes, then soak the grout with more bleach solution. After ten more minutes, rinse the surface with clean water.
The Issue: It's Out of Control
When grout is permanently stained, badly cracked, or crumbling out of the joints, you have no choice but to remove the old grout and re-grout the tiles.
For smaller jobs with ¼-inch or narrower grout joints, use a , which is a small hand tool that has a steel blade covered with super-sharp carbide grit. Simply pull the tool along the joints to “rake” out the grout, as shown below.
For larger jobs—say, more than 30 square feet—or for joints wider than ¼ inch, you need the speed and muscle of an electric grout-removal tool. There are several motorized tools available for removing grout, including grinders, rotary tools, even reciprocating saws. However, the best tool is an fitted with a carbide-grit grout-removal blade. Simply guide the semicircular blade along the joints to grind away the grout, as shown below. And because the multitool blade oscillates back and forth, and doesn’t spin at high speeds, it’s much easier to control than other tools and doesn’t spew out a cloud of dust.
Once the joints are cleaned out, use a wet/dry vacuum to clean the joints of all dust, grit, and loose debris. Then, mix up a fresh batch of tile grout (or buy ), and use a to smear grout diagonally across the surface and deep into the joints.
Wait about 20 minutes, then use a large grout sponge and clean water to wipe off any excess grout. Wait an hour or so and buff the tiles with a clean, dry cloth to remove any residual grout haze. Once the grout is fully cured, apply a silicone-based to increase water and stain resistance of the new grout joints.
The Tools You Need to Clean or Replace Your Grout
OXO Good Grips Heavy Duty Scrub Brush
Chapin International 1 Gallon Sprayer
Goldblatt G02738 Grout Saw